A wire dropped on a socket with a cable in it only takes a line coming
out; the lines going in are the cable's, so it no longer drives one
against the cable. Wired by hand anyway, the check calls that an error,
like a signal sent by two parts. A line going in with neither a wire nor
a cable gets the usual "not connected (reads 0)" warning and marker.
While a wire is drawn over a socket it ends on the socket, where it goes
when let go, not on the pin below. Splitting or joining a port no longer
moves the pins on the other side of the box. Pins on their usual edge
come first, so a wire dropped on the box body takes those, and the cable
button only offers pins whose cable end sits outside the box.
Unpacking a component joins wires on its split lines to the parts that
used the line inside; wires that had nowhere to go are counted in a
notice. Docked panels line up with the moved ports when a project is
opened, not at the next edit.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>