- Right click a component (or its settings): "Cable from outputs" / "Cable into inputs" with the pin groups it has (A0–A3, B0–B3, S0–S3) or all of them
- The cable end plugs onto those pins, the other end waits a few squares away with their names; drop it on the next part's pins and it plugs in there
- Also for input panels (rows out) and hex displays
Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>
- Inside a component, the switch and button rows of its input panels are now input pins (in order with the other inputs, named after the rows); "Rows are component inputs" can be turned off per panel to keep the old fixed switches
- Select input panels, Merge: one panel with all rows, spacing and wires kept; circuits that place this one keep their wires
- Cable ends plug in more often: bundling orders the wires by the part a side runs to, an end with only some wires on a part still plugs, an end placed by hand next to the pins plugs, and dragging an end near its part shows green rings and plugs it on drop
- Hex displays pass their four bits on (outputs on the right), so they can sit in the middle of a bus
- Design the box: move lamps, displays, the screen and the name on a component's box, draw lines, boxes, circles and text in six colours, size it, leave things off; every placed copy shows it
Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>
- Send signal / Use signal: name a signal (CLK, RESET) once and use it anywhere in the circuit without a wire; selecting one lights up all of them, a use with no sender shows dashed
- Inverted inputs: Alt + click an input (or the menu/settings) puts a bubble on it; it reads the signal inverted through one NAND, counted in every transistor total
- Check (Circuit tab): open inputs, parts that drive nothing, duplicate pin names, unsent or doubly sent signals, loops that never settle; click one to show it. Open inputs get an orange marker on the canvas. Components no other circuit uses are listed with a delete
- Cables show the number they carry (= 13 · 0x0D); hovering a wire tells where it runs and its value
- Ctrl+F finds parts, signals, panel rows, notes and components in every circuit, with where each component is used
- Ctrl+P prints the circuit as a sheet with a title block on white paper (or save as PDF); also as an SVG file
- + and − under a selected gate change its number of inputs; swaps keep bubbles in place
- Drag a wire by its end to move that end to another pin; drop a dragged wire on another wire to tap its signal or feed what it fed
Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>
- Right click (or the menu key) shows what can be done with what is under the pointer: one part (open, rename, change to, inputs, colour, speed, panels, unpack, plug and unplug, cable colour), several parts (wire them all to with live preview, connect one by one, switches, change all, arrange, keep only, make a component), wires (bundle, colour, whole signal, straighten, remove cable) or empty canvas (paste here, add a part here, select all, fit, tidy, undo); right drag still moves the view
- "Wire them all to": a card per part, each fit a strip of its pins, and which wire goes where for the fit pointed at
- Plugged cable ends no longer look selected: grey connector, steel clips
- Icons named in menus are bundled for the browser too
Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>