A bubble on a lamp or output pin now shows on it. The truth table, Check,
puzzle scores and gate detection read what an output puts out after its
bubble (they read the raw wire, so a bubble on an output was ignored), and
rows of an output panel count as outputs there (they always read 0).
Right-click on an input pin offers to invert it, for desktops that take
Alt+click for themselves.
Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>
- Send signal / Use signal: name a signal (CLK, RESET) once and use it anywhere in the circuit without a wire; selecting one lights up all of them, a use with no sender shows dashed
- Inverted inputs: Alt + click an input (or the menu/settings) puts a bubble on it; it reads the signal inverted through one NAND, counted in every transistor total
- Check (Circuit tab): open inputs, parts that drive nothing, duplicate pin names, unsent or doubly sent signals, loops that never settle; click one to show it. Open inputs get an orange marker on the canvas. Components no other circuit uses are listed with a delete
- Cables show the number they carry (= 13 · 0x0D); hovering a wire tells where it runs and its value
- Ctrl+F finds parts, signals, panel rows, notes and components in every circuit, with where each component is used
- Ctrl+P prints the circuit as a sheet with a title block on white paper (or save as PDF); also as an SVG file
- + and − under a selected gate change its number of inputs; swaps keep bubbles in place
- Drag a wire by its end to move that end to another pin; drop a dragged wire on another wire to tap its signal or feed what it fed
Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>